
	ショッピングカート: カート内商品数 0 アイテム

ホーム :: Multicopter Parts :: Blade Parts :: Blade Inductrix/E010 Parts :: Beta FPV F4 Brushed Flight Controller(Frsky Rx + OSD)

商品74/268

拡大表示

Beta FPV F4 Brushed Flight Controller(Frsky Rx + OSD)

4,980円

Beta FPV F4 Brushed Flight Controller(Frsky Rx + OSD)

Tiny Whoop用OSD+Frsky受信機内蔵のF4フライトコントローラー！
F411 100MHzのハイパフォーマンスなCPU！
OSDはスマートオーディオポート付

30Aの大容量 MOS FET搭載

本格的なドローンレーサーと同じモード設定できます！
モーターコネクター付きでモーターの交換も簡単です
※受信機はFrsky専用となります

マニュアル

The world's first compatible BetaFlight OSD, FrSky Rx, BetaFlight firmware, born for acro flight controller for the Micro Whoop or Blade Inductrix quadcopter.
Fully programmable through Betaflight, using the onboard USB port, tune all the parameters, PID's, and rates to your perfect settings
Designed to work with current Tiny Whoop or Blade Inductrix setups
Built in SPI Frsky D8 protocol native receiver, compatible with almost ALL Frsky radios(e.g. Taranis X9D/X9D Plus/X7) or Frsky compatible transmitter module
The flight controller board comes pre-flashed with Betaflight firmware, and pre-soldered 55mm power cable pigtail with JST-PH 2.0 connector, AKA PowerWhoop connector.

CPU: STM32F411CEU6
Six-Axis: MPU6000
ESC: All FETs are rated at 30A maximum. Support 6x15mm/7x20mm/8x20mm/8.5x20mm etc motors.
Size: 26mm x 26mm,fully compatible with the Inductrix quad frame and mounting pattern
Firmware version: Betaflight MATEKF411RX 3.4.0
OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
Receiver: SPI Frsky D8 protocol (AKA FRSKY_D on Betaflight Configuration)
Power Cable: 55mm, with JST-PH 2.0 connector, AKA PowerWhoop connector
Weight: 3.7g